Guide: What is an angel's eye? It sounds like a very cute thing. In fact, it is a kind of LED light fixture. Below I will give you a detailed explanation of the installation of the angel eye and the angel eye.
What is the angel's eye:
Angel eye headlights refer to the yellow or other color auras surrounded by low beam and high beam heads, which are beautiful in the state of the wide light. Originally from the design of the BMW 5 Series headlights, when the headlights are turned on, the BMW headlights will have a halo. This aura is very similar to the aura on the angel's head, so many users have given her a nickname: Angel Eye.
Detailed installation of Angel Eye:
Required tools
1. Oven, hair dryer, hot air gun, high temperature resistant glue, slotted screwdriver, cutting tool, file, electric iron, electric drill;
2, LED with resistors and wires (high brightness of 5000mcd or more), resistors, wires;
LEDs generally have red, yellow, blue, green, purple, white, and colorful colors. Generally, green brightness works best, followed by white, followed by blue, yellow, red, and colorful.
How to remove the lampshade
Method 1: directly put the angel eye lamp into the oven, set the temperature to about 120 degrees, then make sure the oven is not preheated, put it in, heat for 5-10 minutes, the heating time varies with the power of the oven, generally After 4, 5 minutes of heating, check it continuously, and watch it with your hand. If the angel's eye lamp is firmer, continue heating. It may take up to 10-15 minutes (see oven power, but it will not exceed 20 minutes). With a hand open, the strength is like opening a solid pencil case. If it is too long, it is estimated that the plastic paste.
Fixed angel eye
The angel eye can be fixed on the lamp frame with high temperature resistant transparent glue. It must be resistant to high temperature glue, because some angel eye lights used by Amoy friends have higher power. After several hours of continuous illumination, the temperature inside the angel eye lamp will be very high. High, if it is ordinary glue, the glue will melt, causing the angel's eyes to fall off, causing a lot of unnecessary trouble.
Once it is fixed, connect the line of the angel's eye directly to the width light. After installing it, light up and try the effect.
Sealed lampshade
Use a heat gun to slowly walk toward the glue on both sides of the angel's eyeshade. This will re-melt. At this time, the lid will be closed, and then a layer of sealant can be applied for double protection.
Antenk box header connector,Those products are used in more or less every known application within computer-, industrial-, telecommunication and specific automotive markets. This product technology allows cost effective connections between printed circuit boards based on removable or permanent connections based on a longterm proofed way of assembly. box header connectors are available with the traditionally used pitch of 2.54mm and the pitch of 2.00mm,1.27mm.
Antenk Box header/Ejector header Description and Application:
Box header/ ejector header connector, With DIP straight/vertical, SMT,Right angle, 2.54pitch, 2.0pitch, 1.27pitch,
The commonly used Pin ways have 6P,8P,10P,14P,16P,20P, 24P,26P,30P,34P, 40P,50P,64P.
Box header/ ejector header and IDC Flat Cable connectors are two of the most commonly used connectors. Box headers can be found in nearly all electronic equipments.
This is a IDC product which allows cost effective connections between circuit boards based on permanent connection (using transition connector) or removable connection
(Using for IDC flat cable connectors).
Box header
Ejector header
Box Header,Box Header Connector,Ecu Box Header Connector,Latch Box Header Connector,1.27mm Box Header Connector,2.00mm Box Header Connector,2.54mm Box Header Connector
ShenZhen Antenk Electronics Co,Ltd , https://www.antenksocket.com