Every bit of progress is slow and arduous, and one person can only solve one limited goal at a time. The following oceans analyze the phenomenon of poor demolding of finished products of coal briquettes.
1. The moisture of the raw material pressed by the briquette ball press is not up to standard, and the humidity is too high, which easily causes blocking and is not good for demoulding. Solution: Moisture control is between 8 and 13 percent. Natural drying or mechanical drying can be used.
2. If the material is not evenly fed into the ball press, if the feed is not even, it is of course not good to release it. The solution is to use an automatic feeder to feed the material on average.
3. The pressure ball machine [url=http://] pressure ball machine [/ url] The ball socket is too small, the pressure ball ball socket size is also related to the ball pressure ball rate, the ball hole is too small, not easy Demoulding, solution, the ball is better than more than 3 cm.
4. The ball machine speed can not be too low, the pressure ball machine speed should be guaranteed between 10-20 rpm, not too low, too low is not easy to pressure ball machine demoulding. want to know