U-tube spiral tube energy-saving lamp application design

Qingdao ASIC design studio Huabeier microelectronics high-frequency source business unit

Key words: Lighting engineering transformation, direct substitution, substitution principle, replacement ratio, abstract: Qingdao Huabeier series, three-color high-frequency high-efficiency industrial special energy-saving lamps (hereinafter referred to as high-frequency high-efficiency energy-saving lamps), is a new type of electric light source. Mainly used in indoor, outdoor, industrial and commercial lighting environments. Direct replacement of high-pressure mercury lamps, sodium lamps, T 8 straight tube fluorescent lamps and incandescent lamps. Guided by the principle of systematics, this paper uses advanced lighting design techniques to propose high-frequency, high-efficiency energy-saving lamps to replace other light source applications. To guide high-frequency and high-efficiency energy-saving lamps, scientifically and correctly apply, to build a bright and comfortable lighting environment in the whole society.
Qingdao Huabeier series, three-color high-frequency high-efficiency industrial special energy-saving lamps. Whether it is a preliminary installation or for lighting engineering. According to the technical characteristics of energy-saving lamps, according to the replacement principle and the replacement ratio, other light sources can be directly replaced.

I. Technical characteristics of Qingdao Huabeier high frequency and high luminous efficiency energy-saving lamps
(1) High light efficiency and high energy saving. Huabel series U-tube spiral tube high frequency and high luminous efficiency energy-saving lamps, electronic ballast AC-DC-AC ( AC-DA-AC ) conversion frequency is high, above 45Khz , high lumen coefficient. The phosphor used in the fluorescent tube is the imported high-quality rare earth trichromatic phosphor specified by our department, and the luminous efficiency is as high as 120Lm/W . The luminous flux attenuation is small, and the luminous flux maintenance rate of 10,000 hours is as high as 92% .
A. Use Huabel series high-frequency high-efficiency energy-saving lamps : Instead of high-pressure mercury lamps and high-pressure sodium lamps, 1W can replace 5W , the ground illumination is 1.5 times higher than the original mercury lamp and sodium lamp, and the power saving rate is over 80% . Turn on the lights for 12 hours a day, and within two to three months, you can recover your investment. See the article on power saving calculation for details.
B, with a high-frequency series Bell CFL luminous efficiency: direct replacement T 8 straight fluorescent lamps, can replace 1W 3.5 W, T8 ground illumination than the original 1.5 times higher in straight fluorescent lamps, the saving rate of 70%. Turn on the lights 24 hours a day, and recover the investment within two to three months. See the article on power saving calculation for details.
For the relationship between the electronic ballast AC-DC-AC conversion frequency and the luminous efficiency of fluorescent tubes, see <The Influence of the Driving Frequency of Electric Light Sources on the Quality of Light Sources>.
(B), high frequency, no stroboscopic effect hazard: Huabei series high frequency and high efficiency energy-saving lamps, electronic ballast AC-DC-AC ( AC-DC-AC) conversion frequency up to 45Khz or more (CE certification regulations at 40Khz the above). The luminous flux fluctuation is less than 5% , and there is no stroboscopic stability. Eliminates the harmful effects of stroboscopic effects. See <offerings on the hazards of electric light stroboscopic effect and countermeasures> article, will help improve production efficiency.
(III) High color rendering performance and vivid color: Huabel series high-frequency high-efficiency energy-saving lamps, fluorescent tubes used by our company, commissioned by our department to produce fluorescent tubes, and custom-made according to the technical parameters designed by our department. The color rendering index R value is greater than 85 , which is close to the color rendering performance of sunlight ( R value = 100 ). Watching colorful objects, vivid and vivid, the lighting environment is bright and comfortable.
(IV) Advanced performance and high reliability: Huabel series high-frequency and high-efficiency energy-saving lamps are designed with advanced fuzzy adaptive control technology. When the voltage fluctuates within the range of 180V-260V , its input power has fuzzy adaptive control characteristics, which are relatively kept within a reasonable range. The whole lamp can work reliably in the long-term range from 180V to 260V . Please refer to the article "Technical Characteristics and Life Accelerated Aging Test Report" in this document.
(V), low failure rate, long life: Huabel series of high-frequency high-efficiency energy-saving lamps, using advanced fuzzy adaptive control technology design, strict security "independent optimization, best match" process technology production and commissioning. The technical performance is advanced, the electronic ballast and the fluorescent tube are matched reasonably, and the quality is stable and reliable. Qihui ignited life: the engineering version lasted more than 15,000 hours. For the fine technical parameters, please refer to the article "U-tube spiral tube energy-saving lamp parameter introduction and power substitution ratio" in this document.
Huabel series high frequency and high efficiency energy-saving lamp products full range, technical quality life:
Market version of each model, specifications:
Qihui ignited a life of 10,000 hours.
Engineering version of each model, specifications:
Qihui ignited life of 15,000 hours of scientific and technical models, specifications:
Qihui ignition life is 20,000 hours
(VI) Strong environmental adaptability: Qingdao Huabeier series high-frequency and high-efficiency energy-saving lamps adopt advanced fuzzy adaptive control technology design, which has strong adaptability to application space environment and power grid environment.
1, hot and humid environment: energy stably and reliably applied to -25 degrees to 10 degrees 5O, 1OO% humidity up where space. (Singapore-owned company, Qingdao Kerry Peanut Oil Co., Ltd., above the wok in the machine press workshop, with a vertical height of 1.2 meters.)
2. Harsh grid environment: It can be used stably and reliably in the grid environment with severe voltage drop, large inrush current and serious harmonic interference. (Taiwan-owned enterprise, Qingdao Wesker Precision Hardware Co., Ltd., high-power DC, AC resistance welding (commonly known as the welding machine) production workshop). For details, please refer to the article "Application Case Selection" in the literature.
(7) Simple installation and low replacement cost: Qingdao Huabeier series high-frequency and high-efficiency energy-saving lamps, there are five series of integrated, split, super power combination, group control, and electronic dimming. Its installation method:
Simply screw into the light Socket.
The other series are split type: the design is equipped with a dedicated cable and a dedicated connector. After the first installation, screw into the socket and insert the connector. No wiring is required, and installation and subsequent replacement are easy. The lamp can be replaced separately in the subsequent process, the replacement cost is greatly reduced, and the running cost is low.
See the article "Comparison of technical and economic performance of integrated and split energy-saving lamps".

Second alternative principles:
The principle of power replacement: the brightness is improved or equivalent after the replacement, and the color rendering performance is improved by 2-4 times or more, and there is no stroboscopic effect hazard.

3. Replacement ratio:
Qingdao Huabeier high-frequency high-efficiency energy-saving lamps directly replace high-pressure mercury lamps, sodium lamps, T 8 straight tube fluorescent lamps and incandescent lamps. Specific technical parameters and technical principles, see the <U-tube spiral tube energy-saving lamp parameter introduction and power replacement ratio> article. For the convenience of reading this article, high-frequency and high-efficiency energy-saving lamps are now substituted with other common light sources and power. The list is as follows:

Huabel high frequency high efficiency energy saving lamp and other common light source power replacement ratio table

4. Operating costs:
Adopting Qingdao Huabeier high-frequency and high-efficiency energy-saving lamps, the power saving rate is 70%-80%, and the running cost is low. Generally, within two to three months, the cost of purchasing lamps can be recovered, and the net profit of electricity saving is considerable. For details on the calculation method of power saving benefit, please refer to the article "Calculation of Power Saving Effect".

5. Shade matching :
Qingdao Huabeier high-frequency high-efficiency energy-saving lampshade is equipped, please follow the <U-tube spiral tube energy-saving lamp shade selection and recommendation> for scientific configuration.

Six. Vertical height:
The electric light source hangs the vertical height and has a great influence on the ground illumination value. The actual vertical height of the electric light source from the ground should be adjusted and optimized according to the lighting design requirements and according to the functional relationship between the operating table illuminance value and the vertical height of the electric light source from the working surface.

Seven. Installation form:
Qingdao Huabeier high-frequency high-efficiency energy-saving lamps, its split installation method: divided into feeder power supply wiring type (Z type), and lamp head power type (D type).
Feeder power connection (Z type): Ballast and lamp assembly, all equipped with dedicated cable and dedicated connectors. After the lighting power supply is connected to the ballast power cord, the other connections are completed with a dedicated connector.
Lamp cap type (D type): Ballast and lamp tube assembly, all equipped with special connecting lines and special connectors. And before the factory, completed the professional connection. As long as the lamp assembly is screwed into the lamp socket (220 volts in the lamp socket), the other connections are completed with a dedicated connector.

Conclusion:
1. Using Qingdao Huabeier high-frequency high-efficiency energy-saving lamps instead of high-pressure mercury lamps and high-pressure sodium lamps, 1W can replace 5W, the ground illumination is 1.5 times higher than the original mercury lamp and sodium lamp, and the power saving rate is over 80%. Turn on the lights for 12 hours a day, and within two to three months, you can recover your investment.
2. Use Qingdao Huabeier high-frequency high-efficiency energy-saving lamp instead of T 8 straight tube fluorescent lamp, which can replace 3.5W with 1W. The ground illumination is 1.5 times higher than the original T8 straight tube fluorescent lamp, and the power saving rate is over 70%. Turn on the lights for more than 20 hours every day, and recover the investment in three to four months.
3. No stroboscopic effect hazard, watch small objects and moving (rotating) objects, clear and true. Visual fatigue is not conducive to improving production efficiency. It is especially suitable for lighting applications such as garment sewing and electronic assembly lines.
4. Color rendering performance: 4 times higher than high pressure mercury lamp (sodium lamp), 2 times higher than T8 straight tube fluorescent lamp, close to the color rendering performance of sunlight. Watch the color of the surface of the colored object, the color is vivid and vivid. It is especially suitable for lighting in textiles, garment and garment lines, etc.
5. U-tube, spiral tube, three-color high-frequency, high-efficiency, high-efficiency, industrial-specific energy-saving lamps, light source lamps, hanging height from the ground, such as the function of the operating table illuminance value and the vertical height of the electric light source from the work surface> optimize. The lighting effect is better.

Han Yurong 1360 630 6833 (0532) 8760830

This product is solar-powered amphibious light. The highly efficient solar panel will convert solar energy into electrical energy and store in the built-in battery for the LED. The specific light-control system makes sure that the light will be charged in the daytime (enough light) automatically and light up in the evening (low light). In addition, it is easy to install, waterproof and dustproof. This product is widely used in the place of roads, courtyards, gardens, pools, etc. It is a perfect light as well as a decoration.

Features
• Solar-powered, energy saving.
• No AC or DC power is needed, easy to install.
• Amphibious design. Waterproof and dustproof, can be put in the water.
• Adjustable head, can be adjusted to 90 degrees.
• Auto sensor, the light can automatically charge itself at day time (enough sunlight) and light up in dark environment.
• Perfect for pool, pond, garden, path road, and other decoration & lighting.
Operation
1. Set the solar panel onto the ground spike and insert into the ground or onto the wall using the top part of the ground spike.
2. Ensure the solar panel is not sheltered from the sun.
3. Set the LED lights where you wish to have them, such as the garden pond, water feature, rock garden etc.
4. Connect the LED lights to the solar panel, In order to ensure that soalr panel is weather proof(IP64), it is important to ensure that LED lights cable and the solar panel cabel are securely screwed together. The cable joint must not be submerged in water.
5. Remove the protective Im on the solar panel and set the switch on the solar panel to the ON position.
6. Once you have completed all the above steps, the LED lights will automatically turn on at dusk.

Notes
1. As the charging effect of the solar panel is depended on the sunlight, the LED light time is affected by weather, seasons, location, etc.
2. The solar panel will charge as long as there is sunlight, regardless of if the ON/OFF is set to OFF or ON. However, the LED lights will only light at the night when the ON/OFF switch is at the ON position.
3. The top of the ground spike can be tightened if the solar panel cannot stay in an upright position.
4. The ground spike is very sharp and as such, you must be cautious while using it. Do not let children play with the ground spike. The solar panel and garden lights should be set up away from children`s play areas.

Solar Underwater Led Light

Solar Led Pool Lights,Solar Underwater Led Light,Waterproof Led Lights,Outdoor Underwater Led Lighting

SHENZHEN CHUXU NEW ENERGY TECH CO., LTD. , http://www.szchuxu.com